Table 26: Global Policy Parameters - Phone Settings; Table 27: Global Policy Parameters - Contact List - Grandstream Networks UCM6100 Series User Manual

Default Call Settings
Dial Plan
Enable Call Features
Use # as Dial Key
Auto Answer by Call-info
NAT Traversal
User Random Port
General Settings
Call Progress Tones
HEADSET Key Mode
LDAP Phonebook
Source
Address
Table 26: Global Policy Parameters – Phone Settings
Configure the default dial plan rule. For syntax and examples, please refer
to user manual of the SIP devices to be provisioned for more details.
When enabled, "Do Not Disturb", "Call Forward" and other call features can
be used via the local feature code on the phone. Otherwise, the ITSP
feature code will be used.
If set to "Yes", pressing the number key "#" will immediately dial out the
input digits.
If set to "Yes", the phone will automatically turn on the speaker phone to
answer incoming calls after a short reminding beep, based on the SIP
Call-Info header sent from the server/proxy.
The default setting is enabled.
Configure if NAT traversal mechanism is activated.
If set to "Yes", this parameter will force random generation of both the
local SIP and RTP ports.
Configure call progress tones including ring tone, dial tone, second dial
tone, message waiting tone, ring back tone, call waiting tone, busy tone
and reorder tone using the following syntax:
f1=val, f2=val[, c=on1/ off1[- on2/ off2[- on3/ off3]]];
•
Frequencies are in Hz and cadence on and off are in 10ms).
•
"on" is the period (in ms) of ringing while "off" is the period of silence.
Up to three cadences are supported.
•
Please refer to user manual of the SIP devices to be provisioned for
more details
Select "Default Mode" or "Toggle Headset/Speaker" for the Headset key.
Please refer to user manual of the SIP devices to be provisioned for more
details.
Table 27: Global Policy Parameters – Contact List
Select "Manual" or "PBX" as the LDAP configuration source.
•
If "Manual" is selected, the LDAP configuration below will be applied to
the SIP end device.
•
If "PBX" is selected, the LDAP configuration built-in from UCM6100
Web GUI→System Settings→LDAP Server will be applied.
Configure the IP address or DNS name of the LDAP server.
UCM6100 Series User Manual
Version 1.0.18.13
P a g e | 112