Firmware Version 1.0.1.22 - Grandstream Networks UCM6100 Series User Manual

•
Added pickup group feature. [Table 87: UCM6100 Feature Codes]
•
Added PSTN detection instructions for "Auto Detect" and "Semi-auto Detect". [PSTN Detection]
•
Added "Auth ID" option for SIP register trunk configuration. [Table 53: Create New SIP Trunk]
•
Added LDAP sync options for peer SIP trunk. [Table 53: Create New SIP Trunk]
•
Changed the default setting of outbound route "Privilege Level" from "Internal" to "International" to avoid
potential misconfiguration and security risk.
•
Added DISA and Fax to IVR key press event options. [IVR Configuration Parameters]
•
Added "Min Message Time" option in voicemail settings. [Table 68: Voicemail Settings]
•
Added Fax setting samples. [Fax]
•
Added DISA support for inbound route and IVR.
•
Added Event List support to monitor local extensions and remote extensions. [BLF AND EVENT LIST]
•
Added feature code *0 for "Disconnect". [Table 87: UCM6100 Feature Codes]
•
Added feature code *8 for "Pickup Extension" in pickup group feature. [Table 87: UCM6100 Feature Codes]
•
Added "Record Prompt" and "Custom Name of Pickup Group" options in internal options. [Table 91: Internal
Options/General]
•
Added warning information for "Allow Guest Call" option to avoid potential security risk caused by
misconfiguration. [Table 102: IAX Settings/General]
•
Changed reset mode to two mode "User Data" and "All".

Firmware Version 1.0.1.22

•
This is the initial version.
UCM6100 Series User Manual
Version 1.0.18.13
P a g e | 38