Figure 20: Ucm6104 Static Route Sample - Grandstream Networks UCM6100 Series User Manual

Gateway
Interface
Static routes configuration can be reset from LCD menu→Network Menu.
The following diagram shows a sample application of static route usage on UCM6104.
The network topology of the above diagram is as below:
•
Network 192.168.69.0 has IP phones registered to UCM6104 LAN 1 address
•
Network 192.168.40.0 has IP phones registered to UCM6104 LAN 2 address
•
Network 192.168.66.0 has IP phones registered to UCM6104 via VPN
•
Network 192.168.40.0 has VPN connection established with network 192.168.66.0
Configure the IPv4 or IPv6 gateway address so that the UCM6100 can reach the
destination via this gateway. Gateway address is optional.
Example:
192.168.40.5 or 2001:740:D::1
Specify the network interface on the UCM6100 to reach the destination using the
static route.
For UCM6102, LAN interface is eth0; WAN interface is eth1.
For UCM6104, LAN1 interface is eth0; WAN interface is eth1.
For UCM6108/UCM6116, only LAN interface is available.

Figure 20: UCM6104 Static Route Sample

UCM6100 Series User Manual
Version 1.0.18.13
P a g e | 70