Table 8: Ucm6104 Network Settings→Basic Settings - Grandstream Networks UCM6100 Series User Manual

IP Method Select Auto or Static. The default setting is Auto
IP Address Enter the IP address for static IP settings.
IP Prefixlen Enter the Prefix length for static settings. Default is 64
DNS Server 1 Enter the DNS server 1 address for static settings.
DNS Server 2 Enter the DNS server 2 address for static settings.
Select "Switch" or "Dual" mode on the network interface of UCM6104. The default
setting is "Switch".
•
Method
•
MTU Specifies the Maximum Transmission Unit. (By default, its 1500)
IPv4
Enter the preferred DNS server address. If Preferred DNS is used, UCM will try to
Preferred DNS Server
use it as Primary DNS server.
LAN (when Method is set to "Switch")
IP Method Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
IP Address Enter the IP address for static IP settings. The default setting is 192.168.0.160.
Enter the subnet mask address for static IP settings. The default setting is
Subnet Mask
255.255.0.0.
Gateway IP Enter the gateway IP address for static IP settings. The default setting is 0.0.0.0.
DNS Server 1 Enter the DNS server 1 address for static IP settings. The default setting is 0.0.0.0.
DNS Server 2 Enter the DNS server 2 address for static IP settings.
User Name Enter the user name to connect via PPPoE.
Password Enter the password to connect via PPPoE.
Layer 2 QoS Assign the VLAN tag of the layer 2 QoS packets for LAN port. The default value is
802.1Q/VLAN Tag 0.
Layer 2 QoS 802.1p Assign the priority value of the layer 2 QoS packets for LAN port. The default value
Priority Value is 0.
Table 8: UCM6104 Network Settings→Basic Settings
Switch
LAN 1 port interface will be used for uplink connection. LAN 2 port interface
will be used as bridge for PC connection.
Dual
Both ports can be used for uplink connection. Users will need assign the
default interface in option "Default Interface". Users will need assign LAN 1 or
LAN 2 as the default interface in option "Default Interface" and configure
"Gateway IP" for this interface.
UCM6100 Series User Manual
Version 1.0.18.13
P a g e | 61