Table 10: Ucm6104 Network Settings->Basic Settings - Grandstream Networks UCM6100 Series User Manual

DNS Server 2
User Name
Password
Layer 2 QoS
802.1Q/VLAN Tag
Layer 2 QoS 802.1p
Priority Value
LAN 1 / LAN 2 (when Method is set to "Dual")
Default Interface
IP Method
IP Address
Subnet Mask
Gateway IP
DNS Server 1
DNS Server 2
User Name
Password
Layer 2 QoS
802.1Q/VLAN Tag
Layer 2 QoS 802.1p
Priority Value
Method
Firmware Version 1.0.10.39
0.0.0.0.
Enter the DNS server 2 address for static IP settings.
Enter the user name to connect via PPPoE.
Enter the password to connect via PPPoE.
Assign the VLAN tag of the layer 2 QoS packets for LAN port. The default value is
0.
Assign the priority value of the layer 2 QoS packets for LAN port. The default
value is 0.
If "Dual" is selected as "Method", users will need assign the default interface to be
LAN 1 (mapped to UCM6102 WAN port) or LAN 2 (mapped to UCM6102 LAN
port) and then configure network settings for LAN 1/LAN 2. The default interface is
LAN 2.
Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
Enter the IP address for static IP settings. The default setting is 192.168.0.160.
Enter the subnet mask address for static IP settings. The default setting is
255.255.0.0.
Enter the gateway IP address for static IP settings when the port is assigned as
default interface. The default setting is 0.0.0.0.
Enter the DNS server 1 address for static IP settings. The default setting is
0.0.0.0.
Enter the DNS server 2 address for static IP settings.
Enter the user name to connect via PPPoE.
Enter the password to connect via PPPoE.
Assign the VLAN tag of the layer 2 QoS packets for LAN port. The default value is
0.
Assign the priority value of the layer 2 QoS packets for LAN port. The default
value is 0.
Table 10: UCM6104 Network Settings->Basic Settings
Select "Switch" or "Dual" mode on the network interface of UCM6104. The default
setting is "Switch".

Switch
LAN 1 port interface will be used for uplink connection. LAN 2 port interface
will be used as bridge for PC connection.

Dual
Both ports can be used for uplink connection. Users will need assign the
default interface in option "Default Interface". Users will need assign LAN 1 or
UCM6100 Series IP PBX User Manual Page 57 of 331