Cleaning The Prints And Postprocessing; Cleaning Of The Printouts With Sinterit Phs Device - SINTERIT LISA PRO User Manual

12. Cleaning the prints and postprocessing

Sinterit offers dedicated tools and devices to facilitate printout cleaning. Depending on the needs, the user can compose
a set tailored to his needs.
For easy cleaning of printouts we recommend:
a. Devices: PHS with an explosion-proof certificate vacuum cleaner, Sandblaster and Sandblaster XL:
b. Tools (only the cleaning tools are shown in the picture - they are part of the Dedicated Powder Tools):
Post Processing Tools (set of Large brushes, set of Small brushes, Metal strainer,
A. CLEANING OF THE PRINTOUTS WITH SINTERIT PHS DEVICE
IMPORTANT!
Cleaning of printouts should be made with a PHS device and vacuum cleaner (a source of pressure).
These steps only concern the cleaning of the printouts. For full instructions on cleaning the printer
and refreshing the powder with PHS, please read the manual of the PHS device.
1. Gently pour the contents of the Print Bed from the IO Box onto the Powder Chamber grid.
2. Clean the IO Box using a brush and put it back in Drawer 2.
ATTENTION!
•
Before starting any work with powder, always wear adequate protective clothing,
eyewear, face mask, and gloves.
•
A suitable set is included in the DEDICATED POWDER TOOLS for Lisa PRO printer as
PERSONAL PROTECTION kit.
Stainless steel probe, Metal spatula) and Foldable Tray
Sinterit LISA PRO User Manual | 43