Finishing The Print - SINTERIT Lisa Pro Shortened User Manual

5. Finishing the print

When the printing process will end, the information
of removing the printout will be displayed.
• By clicking REMOVE PRINT the PRINT BED will raise,
enabling the printout to be taken out from the
chamber.
• By clicking BACK the system will return to the first
screen.
1. When the printing is complete and the printer has
cooled down, YOU CAN NOW REMOVE THE PRINT
FROM PRINTER message will appear on the screen.
Click DONE to complete the printing process and
open the printer.
IMPORTANT!
The lid's lock will stay active until the internal chamber temperature will not drop below
50 [°C].
There is no possibility to open the lid before the temperature drops below acceptable
value.
Remember that the content of the PRINT BED may still be hot, despite the fact that the
printer has cooled down!
2. In order to open the printer, unlock the magnetic lock of the lid (press UNLOCK LID button on the LCD screen).
The lock deactivates for 10 seconds. After 10 seconds the lock will become active again.
3. Softly press the lid and then lift it.
IMPORTANT!
Put on the safety clothing included in the set (mask,
glasses, gloves).
4. Using the provided tools, carefully transfer the
entire content of the PRINT BED to the plate for
carrying the printouts. Transfer it to the mold
included in the set. Leave the content with the
printouts to cool down, for at least one hour
(see image below).
Image 28. Printing finished screen.
Image 29. Printing finished screen.
Image 30. Correct condition of the BEDs content after
printing (visible cracks on the surface).
Sinterit Lisa PRO USER MANUAL (short version) | 11