B) Power Supply - SINTERIT LISA User Manual

 near inflammable and volatile substances, concentrated acids or
corrosive vapors;
 in places easily accessible to children and animals.
ATTENTION!

Never use wood, equipment with wooden elements and flammable
substances at work with the printer.

The minimum distance between the printer and wooden parts is 20 cm.

The printer emits large amounts of heat, and therefore it is prohibited to
put it on the wood and wood furniture.

B) POWER SUPPLY:


Use only the power cord supplied with the product.

The printer must be connected to a grounded outlet to prevent electric shock in the
event of a fault.

When connecting/disconnecting the plug to/from the power source always hold the
cover, not the cord.
WARNING!
Do not use cables from other devices. Using the power cables from other devices
or connecting the power cord supplied with the product to other devices may
cause a fire or electric shock.
ATTENTION!
Never disassemble, modify or repair the power cord, plug, devices inside the
printer, except as described in the product's manual.

The product should be placed near a wall outlet, which can be easily unplugged.

It is recommended to use the UPS units that in the case of a momentary power failure
printing process is not interrupted.

When an extension cord is used for the power supply of the product, make sure that
the total power consumption of all devices connected to it does not exceed the
extension cord's limit. Also, make sure that the total current drawn by connected
equipment does not exceed the ampere rating for AC wall outlet.
16