Configure Service Nat Interfaces; Table 18: Service Port Configuration; Figure 28: Service Port Configuration - Grandstream Networks IPVT10 Administration Manual

Configure Service NAT Interfaces

(Optional) users could customize the service port. Our default service ports are shown as following below:
Server Components Protocol
Media Server TCP/UDP
Media Server UDP
Please, refer to the following steps:
1. Login IPVT10 Web Management UI.
2. Click on the "Service Configuration" on the left side of the UI and select "Port Customization", users
will see the page below:
3. Users could customize the service ports based on the requirements.
4. When users finish updating the ports, users need to click to save the configuration, and click on the
button "Deploy Now" to confirm the customized service ports. The server will reboot to apply the
changes.
Notes:
•
The customized service ports cannot be duplicated.
•
The ports below cannot be set as customized service ports: "25,80,443， 3000， 3306， 5060,5061，
5070，5071,5072，5080，6379，6380，6381，8006，8008，8010，8012，8080， 8081，8083，
9080，80000，26222".
•
If the service ports are set incorrectly, users cannot use the corresponding services normally.

Table 18: Service Port Configuration

Default Port Descriptions
5062 External control port
Port range of media streams:
60000-65000 Requirements: Port starting should not be lower
than 1024, the range is not less than 3000.

Figure 28: Service Port Configuration

IPVT10 Administration Guide
Version 1.0.2.8
P a g e | 54