Time Configuration; Cluster Settings; Figure 29: Time Settings - Grandstream Networks IPVT10 Administration Manual

Time Configuration

Users could check the current time and time-zone of the server and correct it at any time to avoid the
meeting time inaccurate or cannot be launched issues.
Please, refer to the following steps:
1. Login IPVT10 Web UI.
2. Click on "Service Configuration", and configure "Time Settings" options, as the figure shown below:
3. It will show the current time of the server by default.
4. Users could set whether or not to synchronize the SNTP server time. If there is no available SNTP
server, users could adjust the date and time manually.
5. Users need to click to save the configuration, and click on "Apply Now" to update the server time
immediately.

Cluster Settings

Users need to input the IP address of the cluster host server and the cluster code in the slave server to
finish configuration.
Please, refer to the following steps:
1. Login IPVT10 Web UI.
Click on "Service Configuration" → "Cluster Settings", as the figure shown below:
2.

Figure 29: Time Settings

IPVT10 Administration Guide
Version 1.0.2.8
P a g e | 55