Powering On Ipvt10; Figure 5: Ipvt10 Powered On - Grandstream Networks IPVT10 Administration Manual

Notes:
•
Please use the standard three-phase power outlet.
•
Please make sure that the output voltage is within the range of the power module (90~264VAC,
8.5~2.7A, 50/60Hz). If it is not within the working range, correct it and do not power on the
equipment.

Powering on IPVT10

Before powering on the equipment, users need to ensure that the equipment meets the following conditions:
•
If the equipment is installed in a cabinet, please ensure that the screws are fixed, and the equipment
has enough space for heat dissipation.
•
The connections of the cables on the equipment are normal.
•
The input power and current are within the working range of the equipment.
•
The distance between the power cable and the Ethernet cable outside the cabinet must be greater
than 30 mm.
Once the previous conditions are checked, the users can power up the IPVT10 Server. In order to make
the equipment run properly, users need to press the equipment switch in the front panel of the server to
power on the equipment. The indicator will turn to solid green.
After the equipment is turned on, please check the following indicators to make sure the equipment is
working properly.
3
1
2 4

Figure 5: IPVT10 powered on

IPVT10 Administration Guide
Version 1.0.2.8
P a g e | 23