Configure Slave Server; Network Settings; Table 17: Parameters Descriptions; Figure 27: Service Ip Address Config - Network Adapter - Grandstream Networks IPVT10 Administration Manual

Configure Slave Server

Network Settings

Options Descriptions
Parameters
Network Adapter
IPv4 Address
Subnet Mask
Gateway
Preferred DNS
Alternative DNS
NAT
Note:
Ethernet port 1 is used to connect user's PC with the IPVT10 server to login the configuration page of the
device. Users need to connect the Internet with the Ethernet port 2 on the IPVT10 server.
Please, refer to the following steps:
1. Login IPVT10 Web UI.
2. Go to "Service configuration" → "Network Settings", as the figure shown below:

Table 17: Parameters Descriptions

Configures Network Adapter's parameters, which requires to
establish the connection with the host server.
Configures the IP Address for IPVideoTalk Portal.
Configures the Subnet Mask.
Configures the default Gateway.
Set the Preferred DNS.
Set the Alternative DNS.
Enable/Disable NAT, and set the NAT IP address.
Figure 27: Service IP Address Config – Network Adapter
IPVT10 Administration Guide
Version 1.0.2.8
Description
P a g e | 52