Connecting Ipvt10 Server; Connecting Network Cables; Connecting Power Supply Cables; Figure 4: Connecting Ethernet Cables To Ethernet Interfaces - Grandstream Networks IPVT10 Administration Manual

Connecting IPVT10 Server

Connecting Network Cables

In order to ensure to run IPVT10 Server properly, users need to connect the server to a Gigabit switch.
Please connect IPVT10 Server according to the following procedures:
1. Connect the RJ45 Ethernet cable with the Ethernet Interface 1.
2. Connect the RJ45 Ethernet cable with the Gigabit switch.
3. Repeat steps "1" and "2" to connect with Ethernet interface 2.
Note:
•
Please do not use 100M or 10M switches.
•
If only one network is used, only one network interface needs to be connected with the switch
(Internal Network - Setup Ethernet Interface 1, External Network - Setup Ethernet Interface 2).

Connecting Power Supply cables

IPVT10 only supports AC power supply, users can connect the two power supply cables following the steps
below:
1. Connect the standard power supply cable with the equipment.
2. Plug the power supply into the AC power supply.
3. Repeat steps "1" and "2" to connect the second power supply cable.

Figure 4: Connecting Ethernet Cables to Ethernet Interfaces

IPVT10 Administration Guide
Version 1.0.2.8
P a g e | 22