Configure Slave Server - Grandstream Networks IPVT10 Administration Manual

Users could generate a new cluster code in the cluster, and all slave servers cannot connect with the cluster host server
without the new cluster code.
Please, refer to the following steps:
1. Login IPVT10 Web UI.
2. Go to "Service configuration" �� "Cluster Settings" and click on the button
code for the cluster service.
3. Users need to click on the "Save" button to save the configuration and click on "Apply Now" to affect the device.
Then, all slave servers cannot connect with the cluster host server without the new cluster code. Users need to input the
cluster code again in the slave servers to recover the connection with the cluster host server.

Configure Slave Server

Network Settings
Options Descriptions
Parameters Description
Network Configures Network Adapter's parameters, which requires establishing the connection with the host
Adapter server.
IPv4 Address Configures the IP Address for IPVideoTalk Portal.
Subnet Mask Configures the Subnet Mask.
Gateway Configures the default Gateway.
Preferred DNS Set the Preferred DNS.
Alternative DNS Set the Alternative DNS.
NAT Enable/Disable NAT and set the NAT IP address.
Note
Ethernet port 1 is used to connect user's PC with the IPVT10 server to login the configuration page of the device. Users need to
connect the Internet with the Ethernet port 2 on the IPVT10 server.
Please, refer to the following steps:
1. Login IPVT10 Web UI.
2. Go to "Service configuration" �� and "Network Settings", as the figure is shown below:
Table 18: Parameters Descriptions
to generate a new cluster