Installing The Plug-In Transformer - Assa Abloy 5800 ADAEZ PRO Installation And Operation Instructions Manual

®
5800 ADAEZ PRO
Installation and Operation Instructions
8
Miscellaneous Common Insructions

Installing the Plug-In Transformer

USE 24VDC CLASS 2 TRANSFORMER ONLY
NOTE: If possible, the transformer wiring should be
routed against the door trim molding.
NOTE: An optional plug-in transformer is
recommended in installations where the automatic
door-opening feature will be used frequently. The
optional plug-in transformer is REQUIRED for
installations where Power Close and/or Push and Go
features are enabled.
ROUTE WIRE THROUGH
EXIT AT BOTTOM
24VDC (POSITIVE) INPUT
GROUND (COMMON) INPUT
Figure 29
Copyright © 2018, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of ASSA
ABLOY Accessories and Door Controls Group, Inc. is prohibited.
ROUTE WIRE INTO
END LINK FROM
FRONT
DETAIL A
1. ROUTE transformer wiring to a 110-VAC outlet, but
do not plug transformer into the outlet.
2. Refer to Figure 29, and ROUTE wires through
armored cable end links. MOUNT the door cord
end links as follows:
• MOUNT one end link in the area behind or
next to the battery pack.
• MOUNT the other end link on or next to the
door frame.
SEE DETAIL A
SIGNAL INPUT
CHARGER INPUT
31 of 50
EZ061
700002-Rev N 09/18