Determining The Correct Operator Application; Determine The Operator And Door Arm Mounting Installation Type - Assa Abloy 5800 ADAEZ PRO Installation And Operation Instructions Manual

®
5800 ADAEZ PRO
Installation and Operation Instructions
5

Determining the Correct Operator Application

Determine the Operator and Door Arm Mounting Installation Type

The operator must only be installed on doors and
frames that are in good working order. The door must
not stick or bind during normal operation.
If applicable, the existing door closer must be removed
before installing the ADAEZ operator.
The operator must be completely installed and
programmed or the door must be disabled prior to
leaving the site. An incomplete installation or
unprogrammed operator can cause a safety hazard.
LEFT HAND INSWING
NOTES NOTES
1. When the door opens toward you and the knob is on the left hand side, it is a LEFT HAND DOOR. When the door
1. When the door opens toward you and the knob is on the left hand side, it is a LEFT HAND DOOR. When the
opens toward you and the knob is on the right hand side, it is a RIGHT HAND DOOR.
door opens toward you and the knob is on the right hand side, it is a RIGHT HAND DOOR.
2. For the ADA EZ operator, a LH door uses a left hand operator and a RH door uses a right hand operator.
2. For the ADAEZ operator, a LH door uses a left hand operator and a RH door uses a right hand operator.
Figure 4
Figure 5
Copyright © 2018, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of ASSA
ABLOY Accessories and Door Controls Group, Inc. is prohibited.
CAUTION
RIGHT HAND INSWING
PUSH SIDE
APPLICATION
PULL SIDE
APPLICATION
NOTE: A push-mount operator always mounts on the
inside (push side) of the door at the hinge or pivot edge
of the top rail. A pull-mount operator always mounts
on the outside (pull-to-open) of the door.
The ADAEZ will not work on balanced doors or doors
with swing clear hinges.
1. Refer to Figure 4, and DETERMINE desired door
handing.
2. Refer to Figure 5, and DETERMINE if the door is a
push-side application or a pull-side application.
• If the door is a push-side application, GO TO
Section 6.
• If the door is a pull-side application, GO TO
Section 7.
LEFT HAND OUTSWING RIGHT HAND OUTSWING
DOOR OPENING
DOOR OPENING
10 of 50
EZ041A
DIRECTION
DIRECTION
700002-Rev N 09/18