Installing The Door Operator - Assa Abloy 5800 ADAEZ PRO Installation And Operation Instructions Manual

®
5800 ADAEZ PRO
Installation and Operation Instructions
6
Operator And Door Arm Installation Instructions - Push Side Applications
4. If the door is wood or hollow metal, PERFORM the
following:
• Using a 3/8" drill, DRILL the operator
mounting bracket holes.
5. INSTALL and TIGHTEN the supplied through-bolts,
the four ¼-20 socket head capscrews (with
supplied washers) securing the operator mounting
bracket. INSTALL a washer onto each of the four
(minimum) ¾" socket head operator mounting
bracket capscrews.
6. INSTALL, but DO NOT TIGHTEN the socket head
capscrews securing the operator mounting bracket
to the door.
7. ADJUST the operator mounting bracket as follows:
• If the upper fold on the operator mounting
template was used (large stop mounting),
ADJUST the bracket so that there is 2-3/8"
(60 mm) space between the top of the bracket
and the top of the door.
• If the lower fold on the operator mounting
template was used (standard mounting),
ADJUST the bracket so that there is 1¾"
(45mm) space between the top of the bracket
and the top of the door.
• If the narrow stile door mounting location was

Installing the Door Operator

1. Refer to Figure 14, and INSTALL the operator
mounting bracket cover over the operator mounting
bracket.
2. REMOVE the two capscrews securing the operator
bottom cover to the operator.
3. REMOVE the bottom cover from the operator.
4. SLIDE the battery pack from the operator and
REMOVE the battery pack.
5. REMOVE the dress cover from the operator.
used (solid line on operator mounting
template), ADJUST the bracket so that there
is 1/2" (13 mm) space between the top of the
bracket and the top of the door.
8. TIGHTEN the socket head capscrews securing the
operator mounting bracket to the door.
NOTE: The operator mounting bracket includes four
threaded holes that accept the operator mounting pins.
The lower set of two threaded holes is used when the
operator is installed on a narrow-rail door. The upper
set of two threaded holes is used when the operator is
installed on a medium- or wide-rail door.
9. Refer to Figure 13 and PERFORM one of the
following as applicable:
• If the operator is being mounted to a narrow
rail door, TIGHTEN the operator mounting
pins into the lower threaded holes in the
mounting bracket using a 7/16" box wrench
or large adjustable wrench.
• If the operator is being mounted to a wide or
medium rail door, TIGHTEN the operator
mounting pins into the upper threaded holes
in the mounting bracket using a 7/16" box
wrench or large adjustable wrench.
To avoid inadvertent activation of the operator during
connection of the door arm, the battery pack should not
be installed until after the door arm is connected.
6. With the battery pack facing the jamb, POSITION
the operator onto the operator mounting pins.
ENSURE the operator does not slide off the
mounting pins.
7. INSTALL and TIGHTEN the two ¼-20 X 1½" socket
head capscrews securing the operator to the
operator mounting pins.
18 of 50
WARNING
700002-Rev N 09/18