Installing The Door Arm - Assa Abloy 5800 ADAEZ PRO Installation And Operation Instructions Manual

®
5800 ADAEZ PRO
Installation and Operation Instructions
7
Operator And Door Arm Installation Instructions - Pull Side Applications
4. Refer to Figure 25, and , with the door arm
coupling screws facing up, POSITION the larger
end of the door arm onto the operator output shaft.
Align the hole in the end of the door arm
approximately 1/2 hole away from the hole in the
mounting bracket.
The door arm coupling is a two-piece tapered coupling.
In order to draw the coupling halves together evenly
the three door arm coupling screws must be tightened
evenly (one quarter turn at a time) until fully tight.
5. Refer to Figure 26, and, while maintaining the door
arm position, TIGHTEN the door arm coupling
screws evenly (one quarter turn at a time) until fully
tight.
EVENLY TIGHTEN EACH BOLT IN A
CIRCULAR PATTERN 1/4 TURN AT
A TIME UNTIL ALL BOLTS ARE
FULLY TIGHTENED
Figure 26
CAUTION
POSITION 1/2
DIAMETER OUT
FOR PRE-LOAD
Figure 25
6. INSTALL the 5/16 – 18 flat head screw into the
door shoe mounting bracket to secure the door
arm.
7. CYCLE the door several times, and ENSURE that
the door opens and closes smoothly.
8. SLIDE the dress cover onto the operator.
9. CONNECT the battery pack connector plug to the
operator.
10. SLIDE the battery pack onto the operator, and
ENSURE that the battery pack wires will not
interfere with the operator cover.
CENTERLINE OF
DOOR HINGE OR
PIVOT
8-1/4"
28 of 50
14-1/2"
700002-Rev N 09/18