Installing Delayed Egress Exit Device - Assa Abloy Corbin Russwin ED4000 Series Installation Instructions Manual

Delayed Egress
ED4000, ED5000 Series Exit Device
Installation Instructions
9

Installing Delayed Egress Exit Device

Refer to Figure 6 for delayed egress exit device installation wiring.
NOTE: For ElectroLynx Hinge Connector System: Follow Section 6 wiring instructions.
For non-ElectroLynx door:
Remove connector at end of exit device and connect to incoming wires from power source using wire
nuts, butt splices, etc. See Section 14 for hole locations and sizes.
(NO/NC Alarm)
(EGND)
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2006, 2010, 2018, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
(EGND)
(NO/NC Alarm)
(Provided with exit device or QC8 hinge)
3" Typical
12
Electric Hinge - QC8 with
8-Pin Connectors
Figure 6
FM209 10/20