Mounting The Door Arm Pivot Bracket - Assa Abloy 5800 ADAEZ PRO Installation And Operation Instructions Manual

®
5800 ADAEZ PRO
Installation and Operation Instructions
6
Operator And Door Arm Installation Instructions - Push Side Applications
To ensure proper installation, the operator must be
fastened with at least four fasteners. For heavier doors
more fasteners are recommended.
For light duty or hollow-core doors with insufficient top
rail blocking, the included through bolts or sex nut and
bolts must be used to securely attached the operator
mounting bracket.
Figure 8

Mounting the Door Arm Pivot Bracket

NOTE: The face of the triangular vertical support must
be flush against the face of the frame header. On some
door installations, the door stop prevents the bracket
from setting flush. If this is the case, the arm pivot
bracket can be adjusted by removing the bracket
vertical support and reversing it.
In a flush mount installation, the ceiling covers the
frame face. In this case, the vertical support of the
bracket is not used. The bracket should then be
mounted to the underside of the frame header.
CAUTION 7. Using a center punch, MARK the mounting hole
locations.
8. Refer to Figure 8, and, using a square, MARK the
centerline of the arm pivot onto the underside and
face of the frame header and door stop. (This line
is shown on the template.)
EZ043
1. Refer to Figure 9, and DETERMINE if the pivot
bracket must mount to the face of the stop or the
face of the rabbet
2. Refer to Figure 10 and DETERMINE the mounting
location of the triangular vertical support bracket.
• The edge of the bracket must be between
5/8" (16 mm) and 1-1/2" (38 mm) from the
face of door.
• If the door is a typical installation, the
triangular vertical support will set flush
against the face of the frame header.
• If the door is a large reveal installation, the
arm pivot bracket will mount to the
underside of the frame header.
13 of 50
700002-Rev N 09/18