Assa Abloy 5800 ADAEZ PRO Installation And Operation Instructions Manual page 15

®
5800 ADAEZ PRO
Installation and Operation Instructions
6
Operator And Door Arm Installation Instructions - Push Side Applications
To ensure proper installation, the door arm pivot
bracket must be fastened to the underside of the
header frame and to the face of the header frame with
at least three fasteners.
NOTE: When attempting to install the rivnuts to the
underside of the door frame it may be necessary to
remove the door stop.
2. Refer to Figure 11 and, using a center punch,
MARK the door arm pivot bracket hole locations.
3. If the door frame is aluminum and rivnuts must be
installed, PERFORM the following:
Figure 11
CAUTION
OPERATOR MOUNTING BRACKET
FOR NARROW STILE DOORS
OPERATOR MOUNTING BRACKET
FOR ALL OTHER DOORS
a. Using a 25/64" drill, DRILL the door arm pivot
bracket holes.
b. Using the provided rivnut installation tool,
INSTALL the ¼-20 steel rivnuts.
c. INSTALL and TIGHTEN the three (minimum) ¾"
socket head capscrews securing the door arm
pivot bracket to the underside and face of the
frame header.
4. If the door frame is wood, PERFORM the following:
a. Using a 5/32" drill, DRILL the door arm pivot
bracket pilot holes.
b. INSTALL and TIGHTEN the three #14 x 1-¼"
wood screws (minimum) securing the door arm
pivot bracket to the underside and face of the
frame header.
15 of 50
MARK HOLE LOCATIONS
MARK HOLE LOCATIONS
700002-Rev N 09/18