Safety; Overview; For Your Safety - Moog MSD C2 Operation Manual

2

Safety

2.1

Overview

Our devices are state-of-the-art and comply with recognised safety regulations,
nevertheless hazards can arise. In this chapter:
We provide information on residual risks and hazards that can emanate from
y
our devices on usage as intended.
We warn about the foreseeable misuse of our devices.
y
y We refer to the necessary care and measures to be taken to prevent risks.
2.2

For your safety

NOTE
Only install and place in operation your device taking into account the
documentation for the related device family!
Our devices are quick and safe to operate. For your own safety and for the safe
functioning of your device, please be sure to observe the following points:
1.
Follow safety instructions for the devices:
Follow all safety instructions and warnings in the entire documentation related to the device series.
2.
Electric drives are dangerous:
• Due to electrical voltages up to 480 V AC and up to 800 V DC
• Dangerously high voltages of ≥50 V may still be present 10 min. after the power is cut
(capacitor charge). So check that electrical power is not present! See also the warning label on
the front panel on the device.
• Rotating parts
• Automatically starting drives.
• Hot components and surfaces
moog
ID no.: CA97555-001 Date: 04/2018
3.
Protection against magnetic and/or electromagnetic fi lds during
installation and operation.
Persons fitted with heart pacemakers, metallic implants and hearing aids etc. must not be allowed
access to the following areas:
• Areas in the immediate vicinity of electrical equipment!
• Areas in which electronics components and Servo Drives are installed,
repaired and operated!
• Areas where motors are installed, repaired and operated!
Motors with permanent magnets pose particular hazards.
4. During installation observe the following:
• Comply with connection conditions and technical data as per the documentation and the
rating plate!
• Comply with standards and directives on electrical installation, such as cable cross-section,
shielding, etc.!
• Do not touch electronic components and contacts!
Electrostatic discharge can harm people and destroy components!
• Take protection measures and use protective devices as per the applicable regulations
(e.g. IEC/EN 60204 or IEC/EN 61800-5-1)!
• Take "device earthing" protection measure!
5.
Ambient conditions
• Follow the instructions on the transport, storage and correct operation of the devices stated in
the Operation Manual in "A Appendix".
MSD Single-Axis Servo Drive Compact Operation Manual
9