Table of Contents
Advertisement
2. Commissioning
2.6.1 Hardware configuration
2−26
Check network connection, set IP address
1. Click in the Bus Structure" window on the upper entry
of the CPX−SF34/35
2. In the Device Details" window in the IP Settings" tab,
set the IP address and, if necessary, the subnetwork
mask of the CPX−SF34/35. Instructions on setting the
IP address can be found in section 2.4.3.
3. Also set the device name in this window.
1. In the Device Catalog" window, open the folder
Festo\CPX...
The modules are grouped in subfolders. Open the
corresponding subfolders for the modules that you
would like to configure.
2. Configure correspondingly the module sequence in your
CPX terminal:
Pull the modules from the Device Catalog" into the
·
Bus Structure" window under the entry of the
CPX−SF34/35 (see Fig. 2/13).
Festo P.BE−CPX−SF34+SF35−E N en 1007NH
Advertisement
Chapters
Table of Contents
