Table of Contents
Advertisement
2. Commissioning
Fig. 2/14: Assignment of the process data of the CPX−8DE module to the variables of the
PLC by drag & drop
2−30
4. Click in the right window (shows the hardware) on the
first CPX module (here in the example 8DI).
The process data of the module are displayed below the
window.
5. Mark in the list of the process data in the right window
the first 8 entries (click on each with pressed Ctrl key or
other Windows standard procedure). The last line
~DI8" must not be marked.
6. Drag the process data of the right window into the left
window onto the lines of the variables Input0" ...
Input7" (see Fig. 2/14).
7. Click in the right window on the next module in the
module list (here in the example 8DO).
8. Drag the process data of this module as in steps 5 and 6
onto the lines Output0"
9. Carry out this assignment accordingly for all process data
of all modules of your CPX terminal.
This assigns the process data of the CPX terminal to the
variables of the PLC.
Output7"
Festo P.BE−CPX−SF34+SF35−E N en 1007NH
Advertisement
Chapters
Table of Contents
