Festo CPX-SF34 Manual page 63

2. Commissioning
Festo P.BE−CPX−SF34+SF35−E N en 1007NH
Alternative: Automatic generation and assignment
of variables
You can also automatically generate and assign the variables
by module as follows.
1. Change into the Process Data Workspace".
2. Click in the right window (shows the hardware) on the
entry of the CPX−SF34/35.
In the left window, below the Symbols/Variables" tab,
the folder STD_RES " is displayed in the directory tree
(see fig. left).
3. Click once on Default" in the folder STD_RES ".
4. Click in the right window on the first CPX module for
which you would like to generate the variable assign
ment. The process data of the module are displayed
below the window.
5. Mark in the list of the process data in the right window
the first 8 entries (click on each with pressed Ctrl key).
The last line ~DI8" must not be marked.
6. Press Ctrl+E or Create Variable" in the context menu.
In the left window, a new entry Auto" is displayed in the
folder STD_RES ".
7. Click on Auto" to see the assignment list.
8. Carry out steps 4 ... 7 for each module in the
configuration.
2−31