2. Commissioning
Festo P.BE−CPX−SF34+SF35−E N en 1007NH
4. Replace the control block (see section 1.3).
5. Insert the memory card in the new control block.
6. Attach the cover again (see section 1.4.1).
7. Switch the power supply back on. When AUTORUN is
activated (see section 1.4.2), the Boot project stored on
the memory card starts.
8. If necessary, assign the PROFINET device name for the
new control block and set the IP address again.
9. Start the automation program if necessary.
2−41