Prepare The Server For Operation; Install The System Board Assembly - HPE ProLiant MicroServer Gen10 Maintenance And Service Manual

Prepare the server for operation

Procedure
1. Depending on what hardware was replaced, do one or more of the following:
• Install the system board assembly on page 27.
• Install the chassis cover on page 28.
• Install the front bezel on page 29.
2. If removed, attach the security padlock and/or the Kensington security lock.
For more information, see the lock documentation.
3. Connect all peripheral cables to the server.
4. Connect the power cord to the server power jack, and then to the AC source.
5. Secure the power cord and rear panel cables based on the standard cable management practices.
6. Power up the server on page 30.

Install the system board assembly

To secure the system board inside the chassis, install the system board assembly.
Install the system board assembly
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1. Slide the system board assembly into the chassis.
2. Press against the system board assembly until it clicks into place.
3. Install the system board assembly screw.
Prepare the server for operation 27