Prepare The Server For Hardware Installation Or Removal; Prepare The Server For Operation; Remove The Front Bezel; Removing A Locked Front Bezel - HPE ProLiant MicroServer Gen10 User Manual

Prepare the server for hardware installation or removal

Procedure
1. Power down the server on page 22.
2. Disconnect the power cord from the AC source, and then from the server.
3. Disconnect all peripheral cables from the server.
4. If installed, unlock and remove the security padlock and/or the Kensington security lock.
For more information, see the lock documentation.

Prepare the server for operation

Procedure
1. If removed, attach the security padlock and/or the Kensington security lock.
For more information, see the lock documentation.
2. Connect all peripheral cables to the server.
3. Connect the power cord to the server power jack, and then to the AC source.
4. Secure the power cord and rear panel cables based on the standard cable management practices.
5. Power up the server on page 22.

Remove the front bezel

To access the drive bays, remove the front bezel.

Removing a locked front bezel

Prerequisites
1. Power down the server on page 22.
2. Disconnect the power cord from the AC source, and then from the server.
3. Disconnect all peripheral cables from the server.
4. Remove the chassis cover on page 26.
Procedure
1. To unlock the front bezel from the chassis, slide the release tab upward.
Prepare the server for hardware installation or removal 23