Accessing The Marvell Bios Utility Under Legacy Boot Mode; Hpe Smart Storage Administrator - HPE ProLiant MicroServer Gen10 Maintenance And Service Manual

Prerequisites
Accessing the MBU using the RAID command in the UEFI Shell prompt requires system BIOS version
A330 or later. If needed, update the system BIOS.
Procedure
1. Reboot the server.
2. To access the One-Time Boot Menu, press the F11 key when prompted.
3. Select UEFI: Built-in EFI Shell, and then press the Enter key.
4. At the Shell prompt, type RAID, and then press the Enter key.
Shell>RAID

Accessing the Marvell BIOS Utility under legacy boot mode

Procedure
1. Reboot the server.
2. On the POST drive information screen, press Ctrl+M.

HPE Smart Storage Administrator

HPE SSA is the main tool for configuring arrays on HPE Smart Array SR controllers. It exists in three
interface formats: the HPE SSA GUI, the HPE SSA CLI, and HPE SSA Scripting. All formats provide
support for configuration tasks. Some of the advanced tasks are available in only one format.
The diagnostic features in HPE SSA are also available in the standalone software HPE Smart Storage
Administrator Diagnostics Utility CLI.
During the initial provisioning of the server or compute module, an array is required to be configured
before the operating system can be installed. You can configure the array using SSA.
HPE SSA is accessible both offline (either through HPE Intelligent Provisioning or as a standalone
bootable ISO image) and online:
• Accessing HPE SSA in the offline environment
IMPORTANT: If you are updating an existing server in an offline environment, obtain the latest
version of HPE SSA through Service Pack for ProLiant before performing configuration
procedures.
Using one of multiple methods, you can run HPE SSA before launching the host operating system. In
offline mode, users can configure or maintain detected and supported devices, such as optional Smart
Array controllers and integrated Smart Array controllers. Some HPE SSA features are only available in
the offline environment, such as setting the boot controller and boot volume.
• Accessing HPE SSA in the online environment
This method requires an administrator to download the HPE SSA executables and install them. You
can run HPE SSA online after launching the host operating system.
For more information, see HPE Smart Array SR Gen10 Configuration Guide at the Hewlett Packard
Enterprise website.
Accessing the Marvell BIOS Utility under legacy boot mode 77