Install The Expansion Board - HPE ProLiant MicroServer Gen10 Maintenance And Service Manual

Hide thumbs Also See for ProLiant MicroServer Gen10:
Table of Contents

Advertisement

Procedure
1. Remove the full-height bracket from the expansion board.
2. Install the low-profile bracket on the expansion board.

Install the expansion board

Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
Expansion board spare
Procedure
1. Verify that any switches or jumpers on the expansion board are set properly.
Install the expansion board
55

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ProLiant MicroServer Gen10 and is the answer not in the manual?

Table of Contents