Marvell Storage Utility; Installing The Marvell Storage Utility; Marvell Bios Utility; Accessing The Marvell Bios Utility Under Uefi Boot Mode - HPE ProLiant MicroServer Gen10 Maintenance And Service Manual

9. Install the chassis cover on page 29.
10. Connect all peripheral cables to the server.
11. Connect the power cord to the server power jack, and then to the AC source.
12. Power up the server on page 30.

Marvell Storage Utility

The Marvell Storage Utility (MSU) is a configuration and management utility for the embedded Marvell
88SE9230 PCIe to SATA 6Gb/s Controller. This Marvell storage controller supports hardware RAID 0, 1,
and 10 levels. Use the MSU to create and manage RAID virtual disks and arrays using the drives
connected to the embedded storage controller.
To enable MSU access through GUI or CLI, install the MSU in the server.
For more information, see the Marvell Storage Utility User Guide for HPE MicroServer Gen10 in the
Hewlett Packard Enterprise Support Center website:
http://www.hpe.com/info/microservergen10-docs

Installing the Marvell Storage Utility

Procedure
1. Go to the HPE ProLiant MicroServer Gen10 download page:
http://www.hpe.com/downloads/microservergen10
2. Click drivers, software & firmware.
3. Select the server OS from the operating system drop-down menu.
4. Click Utility.
5. Download the Marvell Storage Utility (MSU) for HPE MicroServer Gen10 Server
package to the target server.
6. Unzip the package and open the Marvell_MSU folder.
7. Follow the installation procedure described in the instructions.txt file.

Marvell BIOS Utility

The Marvell BIOS Utility (MBU) is built into the ROM of the embedded Marvell 88SE9230 PCIe to SATA
6Gb/s Controller. This Marvell storage controller supports the hardware RAID 0, 1, and 10 levels. Use the
MBU to create and manage RAID virtual disks and arrays using the drives connected to the embedded
storage controller.
For more information, see the Marvell BIOS Utility User Guide for HPE MicroServer Gen10 in the Hewlett
Packard Enterprise Support Center website:
http://www.hpe.com/info/microservergen10-docs

Accessing the Marvell BIOS Utility under UEFI boot mode

The UEFI boot mode is the server default boot mode.
76 Marvell Storage Utility