Cleaning And Maintenance; General; Cleaning; Replacing Filter, Needle And Measuring Gas Hose - Mocon CheckPoint 3 User Manual

Table of Contents

Advertisement

42
User Guide

Cleaning and Maintenance

General

Performing cleaning and maintenance regularly reduces the chances of equipment failure.
CAUTION! Personnel performing any maintenance or cleaning must familiarize
themselves with the information in
before attempting any of these procedures.

Cleaning

Disconnect cable (if connected) and turn device off by pressing and holding the
for approx. 3 s.
Clean all surfaces using a soft, lint-free cloth with a mild soap solution. Avoid getting
moisture in openings.

Replacing filter, needle and measuring gas hose

During use of the device, dust will over time be sucked through the measuring gas system,
and therefore the filter
The needle
fluid from the packaging from which the measurement is taken.
If this happens, it will be necessary to replace both the filter
.
If there is any dirt or fluid in the measuring gas hose
dry compressed air.
CAUTION! When using compressed air for cleaning, the hose must be disconnected
from the device.
P/N 340486-B
09/2017
will have to be replaced regularly.
may sometimes touch the product being measured or the needle may suck
EN
"Safety and handling instructions" on page 75
, the needle
, it should be replaced or cleaned using
CheckPoint 3
button
, and the hose
DANSENSOR

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CheckPoint 3 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF