Table of Contents

Advertisement

CheckPoint 3

Get started

When you start the device for the first time and before you start making measurements, it is
recommended that you perform some basic device settings.
Select language
Go to
Menu ->
different menus and messages - see
Set up gas concentration alarms
- Basic models:
Go to
Menu ->
should appear on the measurement screen as not acceptable - see
details.
- Premium models:
Gas concentration alarms are set individually for each product - see
for details.
NOTE! You may experience shorter measurement times if appropriate gas alarms
have been set up.
Set up Products and Users
(Premium models only)
From the factory a default user and a default product have been created, but we highly
recommend that you create specific products and users, so that you can separate the
different measurements later on for use in product statistics etc. - see
and
"Users" on page 59
Perform Setup
Go through the parameters available in the
- see
"Setup" on page 56
DANSENSOR
EN
Language to select the language in which you want to view the
"Language" on page 69
Alarm to set values for when the measured gas concentrations
for details.
Setup menu and make appropriate settings
for details.
User Guide
for details.
"Alarm" on page 46
"Products" on page 47
"Products" on page 47
P/N 340486-B
09/2017
23
for

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CheckPoint 3 and is the answer not in the manual?

Related Products for Mocon CheckPoint 3

Table of Contents

Save PDF