Mocon CheckPoint 3 User Manual page 62

60 User Guide
New User
Delete User
User login required
User login with ID
The login function is set up according to table below:
User login required
New User
Creates a new, blank user. The following parameters can be set for a user:
Name
User ID
Supervisor
P/N 340486-B
09/2017
EN
Creates a new, blank user profile.
See "New User" on page 60
Delete user. The action must be confirmed before the user is
deleted.
Select the required type of login.
See table below for details.
User login with ID Function
No login required (default setting)
At start-up the device initializes and when
finished it changes to show the measuring
screen, ready for measuring. Current user
is the default User.
User login required
At start-up the device initializes and when
finished, you are taken to the User screen,
from where you must select a user to go
to the measuring screen, ready for
measuring.
Login with User ID required
At start-up the device initializes and when
finished, you are prompted to enter a valid
User ID.
When done you are taken to the
measuring screen, ready for measuring.
Not possible!
Disabling User login required will
automatically disable User login with ID
as well.
A unique user name (up to 25 characters).
Unique user identification code (up to 25 characters).
The User ID is required to obtain Supervisor access.
Select whether or not the user should be able to obtain
Supervisor access when logging in using the User ID.
When enabled, the user is marked with an
User list.
CheckPoint 3
for details.
symbol in the
DANSENSOR