Login And Access Levels - Mocon CheckPoint 3 User Manual

CheckPoint 3

Login and access levels

(Premium models only)
Login levels
Different levels of login can be set up:
No login
(default setting)
User login required
User login with ID
NOTE! If you forget your User ID, you should create a new (ask a Supervisor).
See "Users" on page 59
Access levels
When device is switched on (after power off ) it is locked in User access level. User access only
gives access to a limited number of functions and does not allow for parameter set-up.
To obtain full access you have to change the device to Supervisor access level.
To do so select Access level from the main Menu - see
DANSENSOR
EN
At start-up the device initializes and when finished it changes
to show the measuring screen, ready for measuring. Current
user is the default User.
At start-up the device initializes and when finished, you are
taken to the User screen, from where you must select a user to
go to the measuring screen, ready for measuring.
At start-up the device initializes and when finished, you are
prompted to enter a valid User ID.
When done you are taken to the measuring screen, ready for
measuring.
for details about user and login settings.
"Access level" on page 65 for details.
P/N 340486-B
User Guide 17
09/2017