Battery And Charging; Prolonged Heat Exposure; Explosive Atmospheres; Cleaning - Mocon CheckPoint 3 User Manual

76 User Guide

Battery and charging

Do not attempt to replace the lithium-ion battery yourself - you may damage the battery,

which could cause overheating and injury. The battery should be replaced only by your
authorized MOCON service provider.
Charge the device with the included power supply, power plugs, and USB cable.

When charging, make sure the USB cable is fully inserted into the power supply before you

plug the it into a power outlet.
If using other third-party cables and power plugs, make sure that they are compatible with

USB 2.0 or later, and that the power supply and plugs are compliant with applicable
country regulations.
Replace damaged cables immediately. Using damaged cables or chargers, or charging

when moisture is present, can cause fire, electric shock, injury, or damage to the device or
other property.

Prolonged heat exposure

The power supply comply with applicable surface temperature standards and limits.

However, even within these limits, sustained contact with warm surfaces for long periods of
time may cause discomfort or injury.
Use common sense to avoid situations where your skin is in contact with the power supply

when it is plugged into a power source for long periods of time. For example, do not place it
under a blanket, when it's plugged into a power source.
It's important to keep the device and the power supply in a well-ventilated area when in

use or charging.

Explosive atmospheres

Charging or using the device in any area with a potentially explosive atmosphere, such as

areas where the air contains high levels of flammable chemicals, vapours, or particles, may
be hazardous. Obey all signs and instructions.

Cleaning

Never use hard tools or abrasive materials when cleaning any part of the device.

Never use cleaning agents containing chlorinated solvents or acetic or phosphoric acid.

These constitute a health hazard and could damage the device.
Avoid getting moisture in openings.

When using compressed air for cleaning, make sure that item has been disconnected from

the device.

Using connectors, ports, and buttons

Never force a connector into a port or apply excessive pressure to a button, because this

may cause damage that is not covered under the warranty.
If the connector and port don't join with reasonable ease, they probably don't match.

Check for obstructions and make sure that the connector matches the port and that you
have positioned the connector correctly in relation to the port.
P/N 340486-B
09/2017
EN CheckPoint 3
DANSENSOR