Confirm The Welding Operation In Teach Mode; Outline; Operation; Display - YASKAWA DX100 Instructions Manual

DX100
2.10

2.10.1 Outline

2.10.2 Operation

2.10.3 Display

2 Basic Operations

2.10 Confirm the Welding Operation in Teach Mode

Confirm the Welding Operation in Teach Mode
ARCON/ARCOF instructions can be executed by TEST RUN in the teach
mode. By this operation, it is possible to confirm the welding conditions.
1. Press [WORK] to turn ON the LED
– Press [WORK] and the LED is lit. Press [WORK] again and the LED
is unlit.
2. Execute the test run (execute the welding)
3. Press [WORK] to turn OFF the LED
If the check run is enabled, turning ON the WORK LED
NOTE
does not execute the welding.
During the execution of the welding, "ARC" is indicated on the job content
display.
Fig. 2-4:
"ARC" Indication During Welding
Executing the test run while "ARC" is indicated on the display executes
the welding.
2-39
CAUTION
HW0485806
156446-1CD