YASKAWA DX100 Instructions Manual page 16

156446-1CD
DX100
2 Basic Operations
2.2 Point Variables
4. Press [ENTER]
– The entered point variable number (T0011) appears in the input
buffer line.
5. Press [ENTER]
– The entered contents are registered in the job. If another point
variable with the same number has been already used in the same
job, the already used point variable, even if no taught position data is
specified in the point variable, is registered. Newly created and
numbered point variable has no taught position data regardless of
SERVO ON/OFF status.
• When a point variable with no taught position data
specified is registered, "" is indicated for the TOOL
number in the JOB CONTENT display.
NOTE
• The job in which the point variable with no taught position
data specified is registered can not be loaded/saved by
FC2 (same as for the position variables).
2-6
HW0485806