YASKAWA DX100 Instructions Manual page 47

DX100
2 Basic Operations
2.9 Overriding Welding Condition Function
• The instruction item (U/D=) to COMARCSET(SCOMARCST)
instruction
When COMARCOF (SCOMARCOF) is executed, the upward/downward
sensing adjustment is disabled.
L/R CONDITION
Move the cursor to the data and press the specific keys to adjust the
sensing condition (left/right).
The left/right side sensing condition is specified by the following
instructions:
• The instruction item (L/R=) to COMARCON (SCOMARCON)
instruction
• The instruction item (L/R=) to COMARCSET (SCOMARCST)
instruction
When COMARCOF (SCOMARCOF) is executed, the left/right side
sensing adjustment is disabled.
DATA EDITING
Indicates whether the edition of a instruction or condition file is
completed or not.
When the conditions set in the instruction or condition file agree with
those set in the welding condition adjustment display, "DONE" is
displayed. When not agree, "UNDONE" is displayed.
During adjustment of the welding conditions by pressing the specific
key, "UNDONE" is displayed, and when [ENTER] is pressed and the
adjusted conditions are registered, "DONE" is displayed.
The welding current and voltage set in the enhanced type
welding condition file can be adjusted by the overriding
NOTE
welding condition function, but the data in the welding
condition file will not be overwritten: the data in the welding
condition file will not be replaced by the adjusted data.
2-37
156446-1CD
HW0485806