Overriding Welding Condition Function; Outline; Operation - YASKAWA DX100 Instructions Manual

156446-1CD
DX100
2.9

2.9.1 Outline

2.9.2 Operation

2 Basic Operations
2.9

Overriding Welding Condition Function

Overriding Welding Condition Function
• During welding, each welding condition such as welding current,
welding voltage, speed, weaving single amplitude, and sensing con-
dition can be adjusted individually by using the specific keys shown
below on the programming pendant.
• The adjusted welding conditions can be automatically set for the tag
and condition file attached to the instruction to set the welding condi-
tion such as ARCON and ARCSET. However, when variables are
used for the welding condition or the condition file, this function is
invalid.
• For overriding the welding conditions, the following keys are used.
• The units for adjusting the welding conditions by pressing the above
keys can be set by the parameters listed in 2.10.5.
1. Select "WELD CND ADJ" from "UTILITY" in the job playback display
– The welding condition adjustment display appears.
2. Move the cursor to the condition to be adjusted
3. Adjust the condition by using the specific keys
– The welding is executed under the adjusted welding condition.
4. Press [ENTER]
– The adjusted welding condition is overwritten in the condition file of
the job.
2-34
TUNING
TUNING
HW0485806