Introduction; Purpose Of The Manual; Safety Symbols; Software Version - Danfoss VLT Active Front End AFE 302 Operating Instructions Manual

Introduction

1 1
1 Introduction

1.1 Purpose of the Manual

1.1.1 How to Read these Operating
Instructions
Please read this manual carefully for proper use. Incorrect
handling of the frequency converter may cause improper
operation of the frequency converter or related equipment,
shorten lifetime or cause other troubles.
These Operating Instructions will help getting started,
installing, programming, and troubleshooting the AFE 302.
Chapter 1 Introduction, introduces the manual and informs
about the approvals, symbols, and abbreviations used in
this literature.
Chapter 2 Safety Instructions and General Warning, entails
instructions on how to handle the AFE 302 correctly.
Chapter 3 Crane System Design, describes the crane system
design associated with the frequency converters.
Chapter 4 How to Install, guides through the mechanical
and technical installation.
Chapter 6 How to Programme, describes how to operate
and programme the AFE 302 via the Local Control Panel
(LCP).

1.2 Safety Symbols

The following symbols are used in this document:
WARNING
Indicates a potentially hazardous situation which could
result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which could
result in minor or moderate injury. It can also be used to
alert against unsafe practices.
NOTICE
Indicates important information, including situations that
can result in damage to equipment or property.
4
Operating Instructions

1.3 Software Version

1.4 Approvals

Table 1.1 Compliance Marks: CE and C-Tick
Danfoss A/S © Rev. 05/2014 All rights reserved.
®
VLT Active Front End AFE 302
Operating Instructions
Software version: 1.15
MG33X402