Table of Contents
Advertisement
Wire buffer empty
Cause:
Counter lever on main wirefeeder open
Remedy:
Close counter lever on main wirefeeder
Acknowledge service code by pressing wire threading button
Cause:
Main wirefeeder slipping
Remedy:
Check wearing parts on wirefeeder
Use suitable feed rollers
Decrease wire braking force
Increase contact pressure on main wirefeeder
Acknowledge service code by pressing wire threading button
Cause:
End of wire reached
Remedy:
Check whether sufficient wire is available
Acknowledge service code using wire threading button
Wirefeed problems
when using long hosepacks
Cause:
Incorrect arrangement of hosepack
Remedy:
Arrange the hosepack in as straight a line as possible, avoid tight bends
Welding torch becomes very hot
Cause:
The specification of the welding torch is inadequate
Remedy:
Observe the duty cycle and loading limits
Cause:
Only on water-cooled systems: Inadequate coolant flow
Remedy:
Check coolant level, coolant flow, for coolant contamination, etc. For further
information refer to the cooling unit operating instructions.
121
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the TPS/i Robotics PushPull CMT and is the answer not in the manual?
Questions and answers