Setting The Contact Pressure For The Wf 60I Robacta Drive Cmt - Fronius TPS/i Robotics PushPull CMT Operating Instructions Manual

Setting the con-
tact pressure for
the WF 60i Robac-
ta Drive CMT
IMPORTANT! In the event of a large change in contact pressure, a system calibration
must be carried out. How to perform the system calibration is explained in the power source
Operating Instructions.
1
1
NOTE! Set the contact pressure in such a way that the wire electrode is not de-
formed but nevertheless ensures proper wirefeeding.
Contact pressure stand-
ard values
Al, AlSi
AlMg
FCW
CuSi
Steel
CrNi
Steel rollers
1 - 2
2 - 4
3 - 5
5 - 7
6 - 8
6 - 8
115