Connecting The Splitbox To The System Components; Safety; General - Fronius TPS/i Robotics PushPull CMT Operating Instructions Manual

Connecting the SplitBox to the system components

Safety

General

Connecting the IMPORTANT! Whenever the torch hosepack is fitted or removed, ensure that the coupling
SplitBox to the point is clean and dry. Remove any coolant that has escaped from the coupling point.
system compo-
nents
1
1
3
3
WARNING! An electric shock can be fatal. Before starting the work described be-
low:
- turn the power source mains switch to the "O" position
- disconnect the power source from the mains
- ensure that the power source remains disconnected from the mains until all
work has been completed
CAUTION! Risk of injury and damage from loose connections. All cables, leads
and hosepacks must be properly secured, undamaged, insulated and adequately
dimensioned.
NOTE! Also follow the instructions and information in the documents
42,0410,1946 and 42,0410,2010 when connecting the wire-feed unit to the sys-
tem components.
2
2
4
4
99