Operation Mode, Temperature, And Fan Speed Settings - Mitsubishi Electric PAR-33MAA Manual

MA REMOTE CONTROLLER

2. Operation mode, temperature, and fan speed settings

Button operation
[ Operation mode ]
Room
Cool Set temp.
Mode Temp.
F1 F2 F3
<What the blinking mode icon means>
The mode icon will blink when other indoor units in the same refrigerant system (connected to the same outdoor unit) are al-
ready operated in a different mode. In this case, the rest of the unit in the same group can only be operated in the same mode.
<AUTO (dual set point) mode>
When the operation mode is set to the Auto (dual set point) mode, two preset
temperatures (one each for cooling and heating) can be set. Depending on the room
temperature, indoor unit will automatically operate in either the Cool or Heat mode
and keep the room temperature within the preset range.
The graph below shows the operation pattern of indoor unit operated in the Auto
(dual set point) mode.
Preset temp.
(COOL)
Preset temp.
(HEAT)
D-12
Press the F1 button to go through the operation modes in the order of
Fri
"Cool, Dry, Fan, Auto, and Heat." Select the desired operation mode.
Auto
Cool
Fan
Auto
F4
• Operation modes that are not available to the connected indoor unit models will
not appear on the display.
Operation pattern during Auto (dual set point) mode
HEAT COOL
Dry Fan
Heat
The room temperature
changes corresponding
to the change in the
outside temperature.
Room temperature
HEAT COOL
ON