Table of Contents
Advertisement
MA REMOTE CONTROLLER
7. Check
7.3. Smooth maintenance
Maintenance data, such as the indoor/outdoor unit's heat exchanger temperature and compressor operation current can be
displayed with "Smooth maintenance".
* This cannot be executed during test operation.
* Depending on the combination with the outdoor unit, this may not be supported by some models.
Button operation
[ 1 ]
Check menu
Error history
Refrigerant volume check
Refrigerant leak check
Smooth maintenance
Request code
Service menu:
Cursor
[ 2 ]
Smooth maintenance
Ref.address
Stable mode
Cool
/ Heat/ Normal
Begin:
Cursor
Address
Smooth maintenance
Ref.address
Stable mode
Cool
/ Heat/ Normal
Stabilization→Collecting
Exit:
[ 3 ]
Smooth maintenance
Ref. address
Cool
COMP. current
COMP. run time
COMP. On / Off
COMP. frequency
Return:
Page
Smooth maintenance
Ref.address
Cool
Sub cool
OU TH4 temp.
OU TH6 temp.
OU TH7 temp.
Return:
Page
Smooth maintenance
Ref.address
Cool
IU air temp.
IU HEX temp.
IU filter time
Return:
Page
D-74
Select "Service" from the Main menu (refer to D-15), and press the
ton.
Select "Check" with the F1 or F2 button, and press the
Select "Smooth maintenance" with the F1 or F2 button, and press
the
button.
Set each item.
Select the item to be changed with the F1 or F2 button.
Select the required setting with the F3 or F4 button.
■ <Ref.address>setting [ 0 ] – [ 15 ]
■ <Stable mode>setting [ Cool ] / [ Heat ] / [ Normal ]
Press the
* Stable mode will take approx. 20 minutes.
The operation data will appear.
A
The Compressor-Accumulated operating (COMP. run) time is 10-hour unit,
Hr
and the Compressor-Number of operation times (COMP. On / Off) is a 100-
times
time unit (fractions discarded).
Hz
Hr
button, Fixed operation will start.
Navigating through the screens
• To go back to the Service menu ..........
• To return to the previous screen .......
P
Main
but-
button.
button
button
Hide quick links:
Advertisement
Chapters
Table of Contents
