5. Function Setting
[ 1 ]
Input maintenance info.
[ 2 ]
[ 3 ]
[ 4 ]
Select "Service" from the Main menu (refer to D-15), and press the
Select "Function setting" with the F1 or F2 button, and press the
Set the indoor unit refrigerant addresses and unit numbers with the F1
through F4 buttons, and then press the
<Checking the indoor unit No.>
If the unit is common or when running all units, all indoor units for the selected
refrigerant address will start fan operation.
Make the settings for the indoor unit functions via the remote contoroller as nec-
Select "Function seting" from the Service menu to bring up the Function setting
When data collection from the indoor units is completed, the current settings ap-
Non-highlighted items indicate that no function settings are made.
Screen appearance varies depending on the "Unit No." setting.
Use the F1 or F2 button to move the cursor to select the mode number,
and change the setting number with the F3 or F4 button.
button is pressed, the target indoor unit will start fan operation.
MA REMOTE CONTROLLER
button to confirm the current