Main Menu List - Mitsubishi Electric PAR-33MAA Manual

MA REMOTE CONTROLLER

2. Main menu list

Setting and display items
Vane · Louver · Vent.
(Lossnay)
High power
Timer On/Off timer
Auto-Off
timer
Filter information
Error information
Weekly timer
Energy Auto return
saving
Schedule
OU silent mode
Night setback
Restriction Temp. range
Operation
lock
Maintenance Auto descending
panel
Manual vane
angle
3D i-See
sensor setting
Initial setting Main/Sub
Clock
Main display Use to switch between "Full" and "Basic" modes for the Main display.
D-8
Use to set the vane angle.
• Select a desired vane setting from five different settings.
Use to turn ON / OFF the louver.
• Select a desired setting from "ON" and "OFF."
Use to set the amount of ventilation.
• Select a desired setting from "Off," "Low," and "High."
Use to reach the comfortable room temperature quickly.
• Units can be operated in the High-power mode for up to 30 minutes.
Use to set the operation On/Off times.
• Time can be set in 5-minute increments.
* Clock setting is required.
Use to set the Auto-Off time.
• Time can be set to a value from 30 to 240 in 10-minute increments.
Use to check the filter status.
• The filter sign can be reset.
Use to check error information when an error occurs.
• Error code, error source, refrigerant address, unit model, manufacturing number,
contact information (dealer's phone number) can be displayed.
* The unit model, manufacturing number, and contact information need to be
registered in advance to be displayed.
Use to set the weekly operation On / Off times.
• Up to eight operation patterns can be set for each day.
* Clock setting is required.
* Not valid when the On/Off timer is enabled.
Use to get the units to operate at the preset temperature after performing
energy-save operation for a specified time period.
• Time can be set to a value from 30 and 120 in 10-minute increments.
* This function will not be valid when the preset temperature ranges are restricted.
* 1°C increments
Set the start/stop times to operate the units in the energy-save mode for each
day of the week, and set the energy-saving rate.
• Up to four energy-save operation patterns can be set for each day.
• Time can be set in 5-minute increments.
• Energy-saving rate can be set to a value from 0% and 50 to 90% in 10% increments.
* Clock setting is required.
Use to set the time periods in which priority is given to quiet operation of
outdoor units over temperature control. Set the Start/Stop times for each day of
the week.
• Select the desired silent level from "Normal," "Middle," and "Quiet."
* Clock setting is required.
Use to make Night setback settings.
• Select "Yes" to enable the setting, and "No" to disable the setting. The temperature
range and the start/stop times can be set.
* Clock setting is required.
* 1°C increments
Use to restrict the preset temperature range.
• Different temperature ranges can be set for different operation modes.
* 1°C increments
Use to lock selected functions.
• The locked functions cannot be operated.
Auto descending panel (Optional parts) Up / Down you can do.
Use to set the vane angle for each vane to a fixed position.
Appears with the units are operated in the energy-save mode with 3D i-see
Sensor.
When connecting two remote controllers, one of them needs to be designated
as a sub controller.
Use to set the current time.
• The default setting is "Full."
Setting details