Operation Mode, Temperature, And Fan Speed Settings - Mitsubishi Electric Mr.Slim PAR-30MAA Technical Manual

Operation mode, temperature, and fan speed settings

Button operation
[ Operation mode ]
Room
Cool Set temp.
Mode Temp.
<What the blinking mode icon means>
The mode icon will blink when other indoor units in the same refrigerant system (connected to the same outdoor unit) are al-
ready operated in a different mode. In this case, the rest of the unit in the same group can only be operated in the same mode.
[ Preset temperature ]
Room
Cool Set temp.
Mode Temp.
[ Fan speed ]
Room
Cool Set temp.
Mode Temp.
16
Press the F1 button to go through the operation modes in the order of
Fri
"Cool, Dry, Fan, Auto, and Heat." Select the desired operation mode.
Auto
Cool
Fan
Auto
• Operation modes that are not available to the connected indoor unit models will
not appear on the display.
<Automatic operation>
• According to a set temperature, cooling operation starts if the room tempera-
ture is too hot and heating operation starts if the room temperature is too
cold.
• During automatic operation, if the room temperature changes and remains
2˚C or more above the set temperature for 15 minutes, the air conditioner
switches to cooling mode. In the same way, if the room temperature remains
2˚C or more below the set temperature for 15 minutes, the air conditioner
switches to heating mode.
Press the F2 button to decrease the preset temperature by 1˚C (1˚F), and
Fri
press the F3 button to increase.
• Refer to the table on page 15 for the settable temperature range for different op-
Auto
eration modes.
• Preset temperature range cannot be set for Fan / Ventilation operation.
Fan
Press the F button to go through the fan speeds in the following order.
Fri
• The available fan speeds depend on the models of connected indoor units.
• Fan speed can be changed even when the buttons are locked or when the sys-
Auto
tem is centrally controlled.
Fan
* The fan speed is changed automatically according to the set temperature and
sensed temperature (room temperature when i-see sensor is not mounted).
Dry Fan
Heat
Auto
Main
ON
Sub