Switches S201, S202, And S801; Mg.20.Y1.22 - Vlt ® Is A Registered Danfoss Trademark; Final Set-Up And Test - Danfoss VLT AQUA Drive FC 200 Instruction Manual

How to Install

4.3.2 Switches S201, S202, and S801

Switches S201 (A53) and S202 (A54) are used to select a
current (0-20mA) or a voltage (-10 to 10V) configuration of
the analog input terminals 53 and 54 respectively.
Switch S801 (BUS TER.) can be used to enable termination
4 4
on the RS-485 port (terminals 68 and 69).
See drawing Diagram showing all electrical terminals in
section Electrical Installation.
Default setting:
S201 (A53) = OFF (voltage input)
S202 (A54) = OFF (voltage input)
S801 (Bus termination) = OFF
NOTE!
When changing the function of S201, S202 or S801, be
careful not to force the switch over. It is recommended to
remove the LCP fixture (cradle) when operating the
switches. The switches must not be operated while the
adjustable frequency drive is powered.
4-22
VLT AQUA 12-Pulse High Power Instruction Manual

4.4 Final Set-up and Test

To test the set-up and ensure that the adjustable
frequency drive is running, follow these steps.
Step 1. Locate the motor nameplate
NOTE!
The motor is either star- (Y) or delta-connected (Δ). This
information is located on the motor nameplate data.
THREE PHASE INDUCTION MOTOR
MOD MCV 315E
kW
HP
mm 1481
Hz
DESIGN
DUTY
INSUL
Step 2. Enter the motor nameplate data in this parameter
list.
To access this list, first press the [QUICK MENU] key, then
select "Quick Set-up". Use the up and down arrow keys to
navigate to the parameters associated with the motor
nameplate values.
1.
2.
3.
4.
5.
®
MG.20.Y1.22 - VLT is a registered Danfoss trademark
Nr. 135189 12 04
400 PRIMARY
536 V 690 A 410.6 CONN Y
V A CONN
50 V A
CONN
N SECONDARY
V A
S1 CONN
I EFFICIENCY % 95.8% 100% 95.8% 75%
CAUTION
1-20 Motor Power [kW]
1-21 Motor Power [HP]
1-22 Motor Voltage
1-23 Motor Frequency
1-24 Motor Current
1-25 Motor Nominal Speed
IL/IN 6.5
SF 1.15
COS f 0.85 40
°C
AMB 40
ALT 1000 m
RISE 80 °C
ENCLOSURE IP23
WEIGHT 1.83 ton